This paper introcudes the design workflow and test approaches of a surface-NMR receiver. But the method and technqiues, for instance, signal loop, acqusition board, GPS synchronization, and Wi-Fi network, could also be employed in other geophysical instruments.

High-power transmitters have been playing a significant role in deep electromagnetic exploration. However, a high-power transmitter needs high-voltage support, which is a potential risk for researchers. According to the actual situation of field exploration, we designed a wireless monitoring system. The system offers two advantages, the first of which is high security; the second advantage is simple operation.

Integrated geophysical techniques (ERT, SSR, and GPR) along the conducted profiles at the Great Pyramids of Giza have been successfully used to investigate the groundwater table and support hazard mitigation. The groundwater table elevation is 15 m under the Great Sphinx, which is safe, and at the Nazlet El-Samman it is 16–17 m.

The article deals with the designation of fault detection on the island of Crete. The delineation is based on the integration method of remote sensing and GIS. The crucial finding is how to differentiate between faults and water streams. The results showed a robust approach to fault detection.

To better understand the influence of sample geometry on laboratory measurements of permeability, the permeabilities of sandstone samples with different lengths and diameters were measured. Despite the large range in length, aspect ratio, and volume, the permeabilities of the samples are near identical. This is due to a homogeneous porosity structure and the small grain/pore size with respect to the minimum tested diameter and length. More tests are now needed to help develop such guidelines.

Raw output of spacecraft magnetometers has to be converted into meaningful units and coordinate systems before it is usable for scientific applications. This conversion is defined by 12 calibration parameters, 8 of which are more easily determined in flight if the spacecraft is spinning. We present theory and advanced algorithms to determine these eight parameters. They take into account the physical magnetometer and spacecraft behavior, making them superior to previously published algorithms.

IZA is a high-mountain station located in Tenerife (Canary Islands, Spain, at 28.3º N, 16.5º W; 2373 m a.s.l.) and is a representative site of the subtropical North Atlantic free troposphere. It contributes with basic-BSRN radiation measurements, such as, global shortwave radiation, direct radiation, diffuse radiation and longwave downward radiation and extended-BSRN measurements, including ultraviolet ranges, shortwave upward radiation and longwave upward radiation.

Focused ion beam (FIB) slicing is a widely used technique to prepare ultrathin slices for the microanalysis of geological and environmental samples. During our investigations of the manganese oxidation states in rock varnish slices, we found an FIB-related reduction of manganese(IV) to manganese(II) at the samples’ surfaces. This study characterizes the observed reduction artifacts and emphasizes that caution is needed in the analysis of transition metal oxidation states upon FIB preparation.

This paper presents a novel method to quantify the sizes and frequency of calving events from time-lapse camera images. The calving front of a tidewater glacier experiences different episodes of iceberg deliveries that can be captured by a time-lapse camera situated in front of the glacier. An automatic way of detecting calving events is presented here and compared to manually detected events.

We highlight the development of a low-cost portable sensor array to study magnetic fields in urban areas. Recent advancements in urban science have demonstrated significant utility in characterizing a city based on physical measurements. Magnetic fields of cities are characterized by significant noise; in the case of the San Francisco Bay Area, this noise is dominated by the BART train system. We demonstrate an ability to identify and extract BART noise from the urban magnetic environment.

The existing current recorder is inadequate for continuous recording, precision, bandwidth, dynamic range, and input range. A new full waveform current recorder that is ideal for measuring current signal for electrical prospecting applications is presented. The full waveform current recorder is capable of measuring current with bandwidth from DC to 10 kHz, with a power spectrum density noise floor of 10 A/rt(Hz) at 10 Hz.

We present the design considerations and deployment of an autonomous modular terrestrial rover for ice-sheet exploration that is inexpensive, easy to construct, and allows for instrumentation customization. The rover proved capable of driving over 20 km on a single charge with a drawbar pull of 250 N, which is sufficient to tow commercial ground-penetrating radars. Due to its low cost, low power requirements, and simple modular design, mass deployments of this rover design are practicable.